Abusemark LCD 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} Abusemark LCD에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Abusemark LCD 5 페이지.
Abusemark LCD에 대해서도 마찬가지입니다: 매뉴얼 (5 페이지)

AbuseMarK LCD Adapter Manual

Improper connection examples

Left image: Cable not aligned correctly, not fully inserted. Powering up like this will likely burn the panel.

Right image: Cable inserted circuit (gold) side down, this is incorrect.

External Power 5V source

When arranging many panels in array, its easier to source a single 5V connector for all panels and avoid

USB cable mess.

A standard 2.54mm (0.1") pin header connection is provided for this purpose. User can solder in pin

header or wires directly. Left‐side is positive (+) and right side is negative (‐). The following 3 pads (tx,

GND, rx) are NOT related to power and 5V must not be connected to them at any time. These pads are

for emergency firmware recovery or debugging.

12/17/2013