Appareo STRATUS ESG 설치 매뉴얼 - 페이지 4

{카테고리_이름} Appareo STRATUS ESG에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Appareo STRATUS ESG 5 페이지. Portable receiver connector plate
Appareo STRATUS ESG에 대해서도 마찬가지입니다: 파일럿 매뉴얼 (13 페이지), 매뉴얼 (9 페이지)

Appareo STRATUS ESG 설치 매뉴얼
3. Wire the connector plate from the transponder to the connector plate following the wiring
diagram on the next page and using the cabling specified under "Additional
Components" above. There is a 3 foot maximum cable length.
4. Connect the ADS-B In receiver to the connector plate. If you are connecting a Stratus
portable receiver, an interface cable kit is available for purchase through approved
Appareo dealers.
Configuring the transponder
The transponder must be configured to allow for ADS-B In receiver information from the cockpit.
1. Enter into configuration mode on the transponder (while holding the FUNC key, press
and release the PWR key).
2. Press FUNC or the arrow keys to navigate to the "ADS-B In Capability" screen and press
ENT.
3. Use the arrow keys to select the frequency that the ADS-B receiver being used in the
aircraft is capable of.
If you are using a Stratus 1 or 1S set the capability to UAT.
If you are using a Stratus 2 or 2S set the capability to UAT and 1090 ES.
If you do not know the frequency, select UAT.
4. Press ENT.
Document Number: 600890-000054
Stratus ESG to Portable Receiver Connector Plate Installation Guide
Revision 1.2
Last Revised: April 27, 2016
Page 4 of 5