Appareo STRATUS ESG 매뉴얼

{카테고리_이름} Appareo STRATUS ESG에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Appareo STRATUS ESG 9 페이지. Portable receiver connector plate
Appareo STRATUS ESG에 대해서도 마찬가지입니다: 파일럿 매뉴얼 (13 페이지), 설치 매뉴얼 (5 페이지)

페이지 인쇄
Appareo STRATUS ESG 매뉴얼
General Install
Q: Can I use Stratus ESG's WAAS GPS signal to feed other
avionics such as a navigator or emergency locator?
No, the WAAS GPS position is only available to the transponder for ADS-B out
purposes, and, if connected, a Stratus portable ADS-B in receiver.
Q: Can I use an existing WAAS GPS antenna with Stratus ESG?
If the antenna meets the specifications outlined in our
instructions
and is not being used for any other avionics, then yes you can.
Must meet TSO-C144 OR TSO-C190 requirements
Q: Can I use an existing transponder antenna with Stratus ES
and Stratus ESG?
If the antenna meets the specifications outlined in our
instructions
and is not being used for any other avionics, then yes you can.
Q: How does the resolution of a serial altitude encoder affect
its configuration with Stratus ES and Stratus ESG?
If the altitude encoder resolution is 25 ft or better (e.g. 10 ft), choose "SERIAL-
TRIM/GAR-25FT" or "SERIAL-SHAD/RMS-25FT."
If the altitude encoder resolution is 25 ft or worse (e.g. 100 ft), choose
"SERIAL-TRIM/GAR" or "SERIAL-SHAD/RMS."
Q: What are the dimensions of Stratus ES and Stratus ESG?
Designed with the common 1.65" tall form factor, it's an easy replacement for
existing transponders.
Bezel Width
6.38 inches (162 mm)
installation
installation