Appareo Stratus Power 설치 지침 매뉴얼 - 페이지 7

{카테고리_이름} Appareo Stratus Power에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Appareo Stratus Power 12 페이지. Dual 2.1 amp usb charging hub

2. Mounting Stratus Power

NOTE: Stratus Power is only compatible with a panel thickness of .040" to .125".

1. Disconnect aircraft power.

2. Locate an area in the panel to mount Stratus Power. The location must provide

adequate clearance in the front and back of the unit based on the dimensions given in

Table 3.

ATTENTION: Process may result in metal shavings. Ensure that they do not fall behind

the aircraft panel.

3. Drill out a circle in the mounting location with a 1 ¼ inch drill bit using the measurements

in Figure 1. Then, cut the notch in the top of the hole.

4. Place the Stratus Power unit behind the panel and align the front of the unit with the

hole. Place the panel cover over the front of the unit and secure with screws.

600840-000041 Stratus Power Installation Instructions

Last Revised: December 15, 2016

Page 7 of 12

Rev. 1.0