Abusemark naze32 매뉴얼 - 페이지 3
{카테고리_이름} Abusemark naze32에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Abusemark naze32 8 페이지. Flight controller
Mini FunFly Flight Controller "Naze32" (なぜ)
Hardware and Connection (Top)
2
RC
Input
(CPPM/PWM)
Status LEDs
Board is 36x36mm square, with mounting holes for M3 screws, spaced 30.5mm.
[1] ESC / Servo Headers
6 motors or 4 motors and up to 2 servos can be connected here. The pins towards
center of the board are signal pins. Following that is 5V, and then Ground/GND pins.
WARNING
Incorrect or reverse connection to these connectors will instantly destroy
the hardware.
[2] RC Input / Servo Output (CPPM / PWM) / GPS connector
* 1 2 3
With the connector facing out, the pins are used as follows. Unmarked pin
(left-most top side) is ground, pin marked with dot is 5V, the rest are RC
signal pins for CPPM (channel 1) or channels 1 through 8. Standard male to
male servo cable can be used to connect a CPPM receiver, then individual
4 5 6 7 8
connectors going to 'signal' pins for any additional PWM channels.
In CPPM input mode, Channels 3 and 4 can be used for
and Channels 5 to 8 can be used for motor outputs.
[3] Buzzer
5V Buzzer, connect a header here, + and - are marked and should be followed.
1
6 ESC/Servo
Headers
Power LED
USB Port
"Front" direction
8
M3 mounting hole
30.5mm spacing
Battery Connector
for Voltage Monitor
4
3.3V
GPS connection. (3:TX, 4:RX),
3
Buzzer connector