Abusemark naze32 Manual - Página 3

Procurar online ou descarregar pdf Manual para Controlador Abusemark naze32. Abusemark naze32 8 páginas. Flight controller

Mini FunFly Flight Controller "Naze32" (なぜ)

Hardware and Connection (Top)

Input

(CPPM/PWM)

Status LEDs

Board is 36x36mm square, with mounting holes for M3 screws, spaced 30.5mm.

[1] ESC / Servo Headers

6 motors or 4 motors and up to 2 servos can be connected here. The pins towards

center of the board are signal pins. Following that is 5V, and then Ground/GND pins.

WARNING

Incorrect or reverse connection to these connectors will instantly destroy

the hardware.

[2] RC Input / Servo Output (CPPM / PWM) / GPS connector

* 1 2 3

With the connector facing out, the pins are used as follows. Unmarked pin

(left-most top side) is ground, pin marked with dot is 5V, the rest are RC

signal pins for CPPM (channel 1) or channels 1 through 8. Standard male to

male servo cable can be used to connect a CPPM receiver, then individual

4 5 6 7 8

connectors going to 'signal' pins for any additional PWM channels.

In CPPM input mode, Channels 3 and 4 can be used for

and Channels 5 to 8 can be used for motor outputs.

[3] Buzzer

5V Buzzer, connect a header here, + and - are marked and should be followed.

6 ESC/Servo

Headers

Power LED

USB Port

"Front" direction

M3 mounting hole

30.5mm spacing

Battery Connector

for Voltage Monitor

3.3V

GPS connection. (3:TX, 4:RX),

Buzzer connector