Data Signs PTL Remote 운영 및 유지보수 매뉴얼 - 페이지 17

{카테고리_이름} Data Signs PTL Remote에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Data Signs PTL Remote 19 페이지. Portable traffic lights

Fault Conditions

If any fault conditions occur as discussed throughout this document, the Portable Traffic

Lights will go to Red.

All critical faults are logged to a file on the SD card fitted to the Master Controller.

The faults logged are outlined below. Reference back to the Australian Standard is provided

in the table.

Fault ID

Description

Yellow

Red

Green

Beacon

Excessive Link

Conflicting Link

Link Timeout

Low Battery

Tilt

To view the current fault log file, select FAULT LOG  VIEW LOGS from the

Mode menu. Use the

The last fault logged is shown first.

A sample fault log entry may be:

F A U L T

X X / X X / X X X X

0 0

Y e l l o w

The time shown with each fault log entry is the time that this fault occurred since the Master

Controller was powered up. The second part is the Portable Traffic Light unit affected (i.e.

Slave#2 or Master). The last part of the entry is the fault description.

Note: The XX/XX/XXXX is not used for PTL Type-1.

You can also use an SD card reader on a laptop/PC to read the fault log files from the SD

card. The file will be in the LOGS directory on the SD card.

Turn the Master Controller OFF and remove the SD card from its slot, leave the power

and

arrow buttons to move through the fault log entries.

L O G

M A S T E R

( O p e n )

OFF while re-inserting the SD card.

P T L O P E R A T I O N S M A N U A L

( 1 / 1 )

0 0 : 0 0 : 1 4