Data Signs PTL Remote 운영 및 유지보수 매뉴얼 - 페이지 7

{카테고리_이름} Data Signs PTL Remote에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Data Signs PTL Remote 19 페이지. Portable traffic lights

SHUTTLE MODE.

This can only be operated via the PTL Remote

Buttons used:

STOP

or GO

A demand for Green or Red signal phase on the Master or Slave is entered on the Remote

Control unit. For Shuttle Control, on start-up, both the Master and Slave will rest on

Red until a demand for Green is entered.

To enter a demand for either Red or Green, press the STOP or GO buttons on the Remote

Control. The DEMAND LED is activated indicating a demand for either the Master or Slave.

REMOTE

ACTIVE

Master / Slave Controller

For display use only

Shuttle Control example:

1. Slave unit is currently showing the Green signal.

2. GO button is pressed for the Master side.

3. If the Green time has expired, the Slave will cycle immediately to Yellow and then Red

signal. The Master DEMAND LED will flash until the Green is lit.

4. Press the GO button on the Slave side to change the Cycle back in the reverse as per above.

5. Note: You can hold BOTH Master and Slave on Red indefinitely by pressing either Red Light.

To return to Green simply select either Master or Slave Green again, the lights will

change when the minimum Red time has expired.

The REMOTE ACTIVE indicator lights up on both the Master and Slave controllers when the PTL

remote is connected.

REAR BEACON LAMP:

The Beacon Lamps mounted behind the Traffic Lights flash on each unit when the Red

Lights are ON.

on PTL Remote.

P T L O P E R A T I O N S M A N U A L

PTL Remote Screen