DURKOPP ADLER Kit 0367 595084 지침 - 페이지 4

{카테고리_이름} DURKOPP ADLER Kit 0367 595084에 대한 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. DURKOPP ADLER Kit 0367 595084 4 페이지. Instructions for converting for manual backtacking

페이지 인쇄

Instructions for converting for manual backtacking

–

Remove two circlips 7 from the shaft 0367 166020.

–

Pull the shaft out.

–

Mount the included shaft and slip circlips on.

–

Tighten the pressure screws of the lever and the frame.

–

Make drillhole 6H13 according to drilling template 0367 165990 (with customary 6 mm steel drill).

–

Knock in pin 2 (part no. 0578 000868).

–

Knock pin 8 (part no. 0994 271360) in the

drillhole already existing and put the included

piece of hose 10 (part no. 0367 165980)

on the pin.

–

Put lever 3 (part no. 0367 165960) on shaft.

–

Hang in spring 4 (part no. 0667 165220).

–

Put clamping block 5 (part no. 0367 166003)

on shaft

With the maximum stitch length the pin 9 of

the clamping block 0367 166003 must abut on

lever 0367 165960.

–

Tighten screw 6 at the clamping block 5.

–

Fasten handle 13 on lever 3 with screws 14

(9204 201667).

–

Adjusting the stitch length: see service

instructions chapter 2.3

–

Adjusting the short tail trimmer

(only with cl. 0367-170315 and 0367-180315):

see service instructions chapter 2.9

–

Mount valve cover, included belt protection,

handwheel and synchronizer

Ausgabe/Edition:

01. 2006

Umbauanleitung für Handverriegelung

Teilesatz 0367 595084

Kit 0367 595084

Printed in Federal Republic of Germany

Teile-Nr./ Part-No.:

13 14

Blatt:

Sheet: 4

0791 367770

von

from 4