DURKOPP ADLER Kit 0367 595084 Інструкція - Сторінка 4
Переглянути онлайн або завантажити pdf Інструкція для Аксесуари для швейних машин DURKOPP ADLER Kit 0367 595084. DURKOPP ADLER Kit 0367 595084 4 сторінки. Instructions for converting for manual backtacking
Друкувати сторінку
Instructions for converting for manual backtacking
–
Remove two circlips 7 from the shaft 0367 166020.
–
Pull the shaft out.
–
Mount the included shaft and slip circlips on.
–
Tighten the pressure screws of the lever and the frame.
–
Make drillhole 6H13 according to drilling template 0367 165990 (with customary 6 mm steel drill).
2
–
Knock in pin 2 (part no. 0578 000868).
–
Knock pin 8 (part no. 0994 271360) in the
drillhole already existing and put the included
piece of hose 10 (part no. 0367 165980)
on the pin.
–
Put lever 3 (part no. 0367 165960) on shaft.
–
Hang in spring 4 (part no. 0667 165220).
–
Put clamping block 5 (part no. 0367 166003)
on shaft
With the maximum stitch length the pin 9 of
the clamping block 0367 166003 must abut on
lever 0367 165960.
–
Tighten screw 6 at the clamping block 5.
–
Fasten handle 13 on lever 3 with screws 14
(9204 201667).
–
Adjusting the stitch length: see service
instructions chapter 2.3
–
Adjusting the short tail trimmer
(only with cl. 0367-170315 and 0367-180315):
see service instructions chapter 2.9
–
Mount valve cover, included belt protection,
handwheel and synchronizer
.
Ausgabe/Edition:
01. 2006
Umbauanleitung für Handverriegelung
Teilesatz 0367 595084
Kit 0367 595084
Printed in Federal Republic of Germany
Teile-Nr./ Part-No.:
13 14
3
9
5
Blatt:
Sheet: 4
0791 367770
4
6
von
from 4