4IPNET EAP717 빠른 설치 매뉴얼 - 페이지 8

{카테고리_이름} 4IPNET EAP717에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 4IPNET EAP717 16 페이지. Enterprise access point

Hardware Installation

Please follow the steps mentioned below to install the hardware of EAP717:

Step 1. Place the EAP717 at the best location. The best location is usually at the center of your intended

wireless network. If admin would like to mount the AP on the wall (on a socket), please refer to the

included EAP717/EAP747/EAP757 Connection Guide. Screw the metal panel to the wall, and then

turn the EAP717 clockwise to fasten to the panel. For installation instructions on the Ceiling Mount

Kit, please refer to the included Connection Guide.

Step 2. Connect one end of the Ethernet cable to the Uplink port and the other end of the cable to a switch,

a router, or a hub. The EAP717 is now connected to your existing wired LAN network.

Step 3. There are two ways to supply power to EAP717

a) Connect the DC power adaptor to the power jack socket.

b) The Uplink port is capable of receiving PoE. Connect an IEEE 802.3af/at-compliant PSE device

(e.g. a PoE-switch) to the Uplink port of EAP717 with the Ethernet cable.

Now, the Hardware Installation is complete.

 Please use only the power adapter supplied with the package. Using a different power adapter

may damage this system.

 To verify the wired connection between the AP and your switch / router / hub, please also check

the LED status indicator of the respective network devices.

EAP717 Enterprise Access Point

Quick Installation Guide

ENGLISH