Cavotec MC-3000 운영 및 유지보수 매뉴얼 - 페이지 6
{카테고리_이름} Cavotec MC-3000에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cavotec MC-3000 9 페이지. Industrial remote control
페이지 인쇄
Micro-control as
2.1.4 Physical Data
Physical size:-
Weight:
2.2 Battery Charger and Batteries
The operating time for a fully charged battery is 8 hours. This time will vary depending on the system
specifications and different operating times may be caused by:-
•
Lower ambient temperatures.
•
A worn out battery.
•
The battery is not fully charged.
•
If the terminal is equipped with additional displays or lamps.
The rechargeable battery should have a lifetime of approx 1000 charging cycles or 2-3yrs. Lifetime
will vary according to the usage.
2.2.1 Changing the battery
•
Put the machine being controlled into a safe position.
•
Turn the terminal OFF.
•
Remove the battery and insert a fully charged one.
•
Turn the terminal ON.
•
Terminals with two batteries fitted can continue to operate, replace only one battery at a time.
2.2.2 Battery Charger Installation and Use
•
Install the battery charger in a clean and dry environment with temperature +10°C - +40°C.
•
Connect the charger to the correct supply voltage.
•
Insert the battery to be charged.
•
Wait to see the indication that charging is normal.
•
Leave the battery in the charger until it is required for use.
•
Use only the battery charger supplied with the system or a replacement from Micro-control.
•
Batteries not in constant use should be charged at least once every 2 months.
2.2.3 Disposing of the batteries
Batteries are hazardous waste and must not be disposed of with normal rubbish. You should dispose
of the batteries according to local laws and rules, or return them to Micro-control as.
2.3 Base unit
All the MC-3-series base units are produced according to the customer's specifications, the wiring
diagram shows how the base unit is connected.
2.3.1 Installation
•
The base unit should only be connected by a competent electrician.
•
Take care that the supply voltage is correct.
•
Install the base unit considering the ambient temperature and IP rating. Ensure it will not be
damaged by moving machinery and allow for easy access.
•
If the installation is subject to harsh vibration use isolating mountings, available from Micro-
control.
MAN-05-006
Operation and Maintenance Manual for MC-3-series
MC-3-5
230x175x160mm
MC-3-6
330x220x200mm
MC-3000
250x158x180mm
MC-3000+
305x200x190mm
2-3 kg
(The weight will vary with the terminal's equipment.)
Page 6 of 9
Rev. 1