Datakom DKG-205 사용자 설명서 - 페이지 14

{카테고리_이름} Datakom DKG-205에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Datakom DKG-205 20 페이지. Automatic mains failure unit

5. PROGRAMMING

The programming mode is used to program the timers, operational limits and

the configuration of the unit.

To enter the program mode, press the PGM button. The display shows (Pr)

when program mode is selected. When the MENU key is pressed the

program number will be displayed, when it is released the program value will

be shown. In this way all program parameters are accessed and the values

can be increased or decreased by using () and () keys.

Programmed values are stored in a Non Volatile Memory, which is not

affected by energy failures. To exit programming, press the OFF button.

P01=MAINS VOLTAGE LOWER LIMIT: If one of the mains phases goes

under this limit, it means that the mains are off and it starts the transfer to the

generator in automatic and test modes.

P02=MAINS VOLTAGE UPPER LIMIT: If one of the mains phases goes over

this limit, it means that the mains are off and it starts the transfer to the

generator in automatic and test modes.

P03=GENERATOR VOLTAGE LOWER LIMIT: If the generator phase

voltage goes under this limit when feeding the load, this will mean a generator

voltage failure and the engine will stop.

P04=GENERATOR VOLTAGE UPPER LIMIT: If the generator phase voltage

goes over this limit when feeding the load, this will mean a generator voltage

failure and the engine will stop.

P05=FREQUENCY LOWER LIMIT: If the generator frequency goes under

this value, it causes an alarm after the frequency delay timer.

P06=FREQUENCY UPPER LIMIT: If the generator frequency goes over this

value, it causes an alarm after the frequency delay timer.

P07=FREQUENCY DELAY: This is the period between the frequency goes

out of the limits and an alarm occurs

P08=DC SUPPLY UPPER LIMIT: If DC Supply voltage exceeds this limit, it

will cause DC Supply alarm after the 2 second delay and the diesel will stop.

This alarm is particularly designed to prevent failure of the unit in case of

charge alternator failure.

P09=NUMBER OF STARTS: Maximum number of start attempts.

P10=WAIT BEFORE START TIMER: Waiting period between the fuel on and

start command.

P11=WAIT TIMER BETWEEN STARTS: Waiting period between two start

attempts.

P12=START TIMER: Start period. Start will be automatically deactivated if the

generator starts running before the timer.

P13=STOP TIMER: Stop solenoid activation timer. Enter 0 for an 'activate to

start' type of engine.

- 14 -