Elsner KNX L 기술 사양 및 설치 지침 - 페이지 7

{카테고리_이름} Elsner KNX L에 대한 기술 사양 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Elsner KNX L 8 페이지. Brightness sensor

2.3.3. Preparing the sensor

Unsnap cover and

remove upwards

Fig. 7

Cover Snaps

Bottom part of housing

The sensor cover snaps in on the left and right along the bottom edge (see Fig.). Re-

move the cover.

Push the bus connection cable through the rubber seal on the bottom of the sensor and

connect bus +/- to the provided clamps.

2.3.4. PCB layout

2.3.5. Mounting the sensor

Close the housing by putting the cover back over the bottom part. The cover must snap

in on the left and right with a definite "click".

KNX L brightness sensor • Date of issue: 05.11.2010 • Technical changes reserved. Errors reserved.

Installation and commissioning

Fig. 8

Slot for KNX clamp +/-

Programming LED

Programming pushbutton for

the teach-in of the device