Datalogic CBX500 설치 매뉴얼 - 페이지 12

{카테고리_이름} Datalogic CBX500에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Datalogic CBX500 17 페이지. Scanning connection box
Datalogic CBX500에 대해서도 마찬가지입니다: 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (17 페이지)

페이지 인쇄

CBX500 INSTALLATION MANUAL

CHASSIS GROUNDING JUMPER SETTINGS

The reading device chassis grounding method can be selected by positioning a jumper (see

Figure 8). In this way the reading device chassis can be connected to earth ground (only if

pin Earth is connected to a good earth ground). For all reading devices except 6K/8K, the

chassis can alternatively be connected to the power supply ground signal (GND) or it can be

left floating but, in this case, the jumper must be removed. For 6K or 8K scanners the chassis

is internally connected to GND.

All Reading Devices (except 6K/8K)

to GND

The scanner chassis is

internally connected to GND

6K, 8K Family Scanners

9-PIN READING DEVICE AUXILIARY SERIAL INTERFACE

The reading device auxiliary serial interface available on the internal CBX500 9-pin

connector can be used either for configuration or for data monitoring.

Connections can be made to a PC or Laptop using a straight through cable or a USB-RS232

converter.

The details of the connector pins are indicated in the following table:

1, 4, 6, 7, 8, 9

floating

to Earth (default)

Figure 8 – Chassis Grounding

Figure 9 - 9-pin D-Sub Female Connector

9-pin Connector Pinout

Name

Function

Auxiliary RS232

SGND

Auxiliary Reference Ground

N.C.