Elsner Suntracer KNX basic Series 기술 사양 및 설치 지침 - 페이지 7

{카테고리_이름} Elsner Suntracer KNX basic Series에 대한 기술 사양 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Elsner Suntracer KNX basic Series 12 페이지.

2.2.3. Preparing the weather station

Unsnap cover

and remove upwards

Fig. 9

Screw-on cover (230V

device)

Cover with rain sensor

Cover snaps

Bottom part of housing

The weather station cover with the rain sensor snaps in on the left and right along the

bottom edge (see Fig.). Remove the weather station cover. Proceed carefully, so as not

to pull off the wire connecting the PCB in the bottom part with the rain sensor in the

cover (soldered cable connection in case of 230 V AC version, cable with plug in case

of 24 V DC version).

Push the power supply and bus connection cable through the rubber seal on the bot-

tom of the weather station and connect voltage LN and bus +/- to the provided clamps.

Weather Station Suntracer KNX basic • Status: 15.07.2013 • Technical changes reserved. Errors reserved.

Installation and commissioning