Datalogic Gryphon D100 빠른 참조 - 페이지 7

{카테고리_이름} Datalogic Gryphon D100에 대한 빠른 참조을 온라인으로 검색하거나 PDF를 다운로드하세요. Datalogic Gryphon D100 20 페이지.
Datalogic Gryphon D100에 대해서도 마찬가지입니다: 참조 매뉴얼 (20 페이지)

페이지 인쇄

1 DEFAULT

Read the RESTORE DEFAULT.

Leggere il codice che ripristina i default.

Lecture du code de configuration par défaut.

Lesen Sie den Restore Default Code, um die

Werkseinstellung wieder herzustellen.

RS232 Standard DEFAULT SETTINGS

9600 baud, no parity, 8 data bits, 1 stop bit, no handshaking,

delay disabled, rx timeout 5 sec., ack/nack disabled, FIFO

enabled, serial trigger lock disabled;

DATA FORMAT

code length not transmitted, no header, terminator = CR-LF,

character replacement disabled

RS232 Nixdorf DEFAULT SETTINGS

9600 baud, parity odd, 8 data bits, 1 stop bit, handshaking

hardware (RTS/CTS), delay disabled, rx timeout 9.9 sec.,

ack/nack disabled, FIFO enabled, serial trigger lock disabled;

DATA FORMAT

code length not transmitted, no header, terminator = CR,

character replacement disabled

RS232 Fujitsu DEFAULT SETTINGS

9600 baud, no parity, 8 data bits, 1 stop bit, no handshaking,

delay disabled, rx timeout 2 sec., ack/nack disabled, FIFO

enabled, serial trigger lock disabled;

DATA FORMAT

code length not transmitted, no header, terminator = CR,

character replacement disabled

RS232 ICL DEFAULT SETTINGS

9600 baud, parity even, 8 data bits, 1 stop bit, handshaking

RTS always on, delay disabled, rx timeout 9.9 sec., ack/nack

disabled, FIFO enabled, serial trigger lock disabled;

DATA FORMAT

code length not transmitted, no header, terminator = CR,

character replacement disabled

WEDGE DEFAULT SETTINGS

USA keyboard, caps lock off, num lock unchanged, inter-

character and inter-code delays disabled, control character

emulation = ctrl+shift+key;

RESTORE DEFAULT

: code identifier disabled, no field adjustment,

: code identifier enabled, no field adjustment,