elsner elektronik KNX LW sl 기술 사양 및 설치 지침 - 페이지 11
{카테고리_이름} elsner elektronik KNX LW sl에 대한 기술 사양 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. elsner elektronik KNX LW sl 13 페이지. Brightness and wind sensor
페이지 인쇄
2.6. After the auxiliary voltage has been applied,
the device will enter an initialisation phase
lasting a few seconds. During this phase no
information can be received via the bus.
3.
Addressing the equipment
The equipment is delivered ex works with the bus address 15.15.250. You program a
different address in the ETS by overwriting the address 15.15.250 or teach the device
using the programming button.
The programming button can be reached through the opening on the underside of the
housing; it is recessed by approx. 15 mm. Use a thin object to reach the key, e. g. a
1.5 mm² wire.
Fig. 17
1
Programming button for teaching the device
2
Programming LED (under the semi-transparent lid)
Brightness and Wind Sensor KNX LW sl • Status: 05.11.2014 • Errors excepted. Subject to technical changes.
11
1
2
Addressing the equipment