elsner elektronik KNX LW sl 기술 사양 및 설치 지침 - 페이지 9
{카테고리_이름} elsner elektronik KNX LW sl에 대한 기술 사양 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. elsner elektronik KNX LW sl 13 페이지. Brightness and wind sensor
페이지 인쇄
A
Pole installation
The device is installed on the pole with the enclosed stainless steel mounting band.
Rubber
gasket
Cable guide
2.4.3. Connection
The connector is in the lower part of the housing.
Brightness and Wind Sensor KNX LW sl • Status: 05.11.2014 • Errors excepted. Subject to technical changes.
9
B
C
Fig. 12
Feed the mounting band through the eyelets
in the lower part of the housing.
Fig. 13
Break the cable guide off.
Feed the power lead through the rubber gas-
ket.
Installation and start-up
Fig. 11
Dimensions in mm. Variations are
possible for technical reasons
A/B 2× longitudinal holes 8 mm ×
5.5 mm
C
Position of the cable outlet (rub-
ber gasket) in the housing