elsner elektronik 70391 설치 및 조정 - 페이지 10

{카테고리_이름} elsner elektronik 70391에 대한 설치 및 조정을 온라인으로 검색하거나 PDF를 다운로드하세요. elsner elektronik 70391 18 페이지. Door operator control module

페이지 인쇄
elsner elektronik 70391 설치 및 조정
No.
Text
22
Input 2 Relative Dimming
23
Input 2 Encoder 8 bit
24
Input 2 Encoder Temperature
25
Input 2 Encoder Brightness
26
Input 2 Scene
27
Software version
5.

Parameter setting

The parameter defaults are underlined.

5.1. General settings

Set themaximum telegram rate:
Maximum message rate

5.2. Door operator

You define the operating mode for the outputs in the Door operation menu.
Operating mode
If only one door is connected to the three outputs (two- or three-button operation,
output 1 = open, output 2 = close, if needed output 3 = stop), select Defined Open/
Close/Stop mode or Impulse mode.
If a door is connected to each output (single-button operation), select Impulse mode or
dead-man mode.
Defined Open/Closed: (1 door)
The outputs 1 and 2 react to the object (are assigned to the object) Output 1+2 -
Impulse. If the object value is 1, then output 1 receives an impulse (closes for 1s). If the
object value is 0, then output 2 receives an impulse (closes for 1 s).
Output 3 is asigned to the object Output 3 - Impulse. The output reacts as soon as an
object has been received (no matter which value).
Select whether output 3 is a normally closed or normally open contact (duration of
opening/closing 1 second).
Operating mode
Allows control of one door
Door operator control module KNX A3-B2 • Status: 17.12.2019 • Technical changes and errors reserved.
8
Function
Input/Output
Output
Output
Output
Output
Readable
1 • 2 • 5 • 10 • 20 messages per second
• Defined Open/Close/Stop
• Impulse mode
• Dead-man mode
Defined Open/Closed/Stop
Parameter setting
DPT
Length
(byte)
3.007
1
5.*
1
9.001
2
9.004
2
18.001
1
217.001
2
Flags
RWCT
R CT
R CT
R CT
R CT
R C