elsner elektronik KNX RW Series 기술 사양 및 설치 지침 - 페이지 7

{카테고리_이름} elsner elektronik KNX RW Series에 대한 기술 사양 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. elsner elektronik KNX RW Series 11 페이지. Rain/wind sensor

2.3.3. Preparing the sensor

Unsnap cover and

remove upwards

Fig. 9

Screw-on cover (230V

device)

Cover with rain sensor

3) Cover Snaps

Bottom part of housing

The sensor cover snaps in on the left and right along the bottom edge (see Fig.). The

cover of the 230V model is also screwed on top. Remove the cover. Proceed carefully,

so as not to pull off the wire connecting the PCB in the bottom part with the rain sensor

in the cover (soldered cable connection in case of 230 V AC version, cable with plug in

case of 24 V DC version).

Lead the cable for the voltage supply and bus connection through the rubber seals on

the bottom of the device and connect Voltage L/N and Bus +/- to the terminals provid-

ed.

For 24V devices the connection cable must be plugged in between the cover and circuit

board.

Rain/Wind Sensor KNX RW • Status: 19.08.2013 • Technical changes reserved. Errors reserved.

Installation and commissioning

Fig. 10

Remove the cable shielding under the circuit

board and only feed the connector cables up-

wards through the openings in the circuit

board.