Dustbane Gladiator 712 + Rider 운영 매뉴얼 - 페이지 12
{카테고리_이름} Dustbane Gladiator 712 + Rider에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dustbane Gladiator 712 + Rider 19 페이지. Gladiator series
5. Open the cowling and use the internal combustion engine starting handle. When the engine is cold,
you also need to use the choke (INTERNAL COMBUSTION ENGINE with manual pull start).
6. Use the lever to activate the drive.
7. Press the suction button.
8. Adjust pressure of the center brush on the floor using the knob according to the type of floor and dirt
to be picked up. Turn it clockwise to increase pressure and anticlockwise to reduce pressure on the
work surface.
9. Lower the side brush using the lever.
10. Start cleaning, maneuvering the handgrip with the hands and acting on the drive control.
To avoid damaging the surface of the floor to be treated, avoid rotating the brushes with
the machine stationary.
Important
Do not pick up wire, string or plastic straps.
Important
Each 30 minutes of work, activate the filter shaker button (fig. C, ref. 4) for 30 seconds to
clean the suction filter. During this operation, the suction fan shuts off automatically.
Important
7. Periods Of Inactivity
1. Disconnect the battery. To optimize the working life of the battery, it should be charged every 30/40
days.
2. Empty the bins.
3. Clean the machine in general.
4. Clean the suction filter.
8. Maintenance Instructions
Maintenance on the electrical circuit and all other operations not explicitly described in
this manual must be performed by specialized personnel only, in compliance with current
safety legislation and as described in the maintenance manual.
Danger
For all maintenance on the engine, see the instruction book.
Never perform any maintenance operations without first disconnecting the batteries from
the machine's electrical circuit.
Danger
8.1. Maintenance - General rules
Performing regular maintenance according to the Manufacturer's instructions improves
performance and extends the working life of the machine.
When cleaning the machine, respect the following:
1. avoid the use of high pressure washers. Water could penetrate the electrical compartment or motors
leading to damage or the risk of short circuit;
2. do not use steam to avoid the heat warping plastic parts;
3. do not use hydrocarbons or solvents as they could damage the cowling and rubber parts.
10