Dustbane Gladiator 712 + Rider 운영 매뉴얼 - 페이지 16

{카테고리_이름} Dustbane Gladiator 712 + Rider에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dustbane Gladiator 712 + Rider 19 페이지. Gladiator series

8.2.7. Drive belt 712: replacing

• Rotate the cowling.
• Remove the belt (ref. 1) from the groove of the pulleys.
• Fit the new belt (ref. 1) onto the pulleys.

8.3. Regular maintenance

8.3.1. Daily operations

1. Empty the bins.
2. Make sure there are no wires or straps rolled around the center brush.
3. Recharge the batteries according to the procedure described.

8.3.2. Weekly operations

1. Check for wear of the FLAPS. If necessary, replace.
2. Check the condition of the suction air filter and make sure it is undamaged. If necessary, replace.

8.3.3. Six monthly operations

• Have the electricity circuit checked by qualified personnel.
Table of Maintenance
• A : On receipt
• B : Every 10 hours
• C : Every 50 hours
• D : Every 100 hours
CHECK
Center brush: make sure there are no straps or nylon cord wrapped
around the brush. If necessary, remove
Center brush: check wear of the brush
Side brushes: check wear of the brushes
Flap / Bin gasket: check wear of the flaps and gaskets
14
A
B
C
D