Datalogic DS1100 SH2347 특별 지침 - 페이지 2

{카테고리_이름} Datalogic DS1100 SH2347에 대한 특별 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Datalogic DS1100 SH2347 2 페이지. 10 - 30 vdc
Datalogic DS1100 SH2347에 대해서도 마찬가지입니다: 빠른 매뉴얼 (9 페이지)

페이지 인쇄

Power Supply

Power can be supplied to the scanner through the pins provided on the
25-pin connector used for communication with the host.
The power must be between 10 and 30 Vdc only.
SCANNER
13/9
VS
25
GND
1
CHASSIS
Inputs
The yellow LED is on when the External Trigger forces a current flow
through the EXT TRIG+ and EXT TRIG- pins.
This input is optocoupled and can be driven by both an NPN or PNP type
command. The connections are indicated in the following diagrams:
SCANNER
+ 5V
18
EXT TRIG+
19
EXT TRIG-
Figure 2 - Input NPN command using external power
SCANNER
9
+ 5V
18
19
25
Figure 3 - Input NPN command using scanner power
USER INTERFACE
V+ (10 - 30 Vdc)
GND
Vext
30 Vdc max.
EXTERNAL TRIGGER
V
Signal
EXTERNAL TRIGGER
VS
V
EXT TRIG+
EXT TRIG-
Signal
GND
Ground
SCANNER
+ 5V
18
EXT TRIG+
19
EXT TRIG-
Figure 4 - Input PNP command using external power
SCANNER
9
+ 5V
18
19
25
Figure 5 - Input PNP command using scanner power
For DS1100, the general purpose input IN1 is used in the Standard
Application Program to store the code verifier (see "Store Verifier HW" in the
WinHost Help On Line). Use the input connections indicated in the figure
below. For DS2200, this input is not used.
SCANNER
13/9
VS
47 K
17
IN1 -
I/O REF
22
Figure 6 - IN1 - Input command
Vext
30 Vdc max.
EXTERNAL TRIGGER
V
Signal
Ground
EXTERNAL TRIGGER
VS
V
Signal
EXT TRIG+
EXT TRIG-
GND
Ground
USER INTERFACE
V
Ground