CB-tec neocube-o 운영 매뉴얼 - 페이지 17

{카테고리_이름} CB-tec neocube-o에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CB-tec neocube-o 20 페이지.

6. COMMISSIONING THE UNIT

1. Remove the weather protection hood (if provided).

2. Check that the gas is connected correctly to the gas cylinder

and open the cylinder.

Secure the gas cylinder with the rubber mounting piece.

 

1. Turn the ignition knob on the gas control panel (Fig. 4) as far to the right as possible. Push in the ignition knob. Then, turn it to

the left, keeping it pushed in until you hear a "click" (Fig. 5). This "click" is the ignition of the pilot light. If necessary, repeat this

process 3-5 times until the pilot light is burning.

2. Once the pilot light is lit, continue holding in the ignition knob for another 10 seconds. Then release the ignition knob.

3. If the pilot light goes out, repeat steps 1 and 2 until the pilot light starts burning.

Caution: If a new gas cylinder is installed or the fireplace has not been used for a while, you first have to release the air from the

gas hose. This may take a while before the pilot light ignites.

After the pilot light starts burning, the ignition knob (Fig. 6) has to be turned to the left. Now the main burner (Fig 1) is supplied with gas.

1. The desired height of the gas flame can be adjusted by turning the flame height controller (Fig. 7) to the right or left.

2. For a lower gas flame, turn the knob clockwise to the right (Fig. 8).

3. For a higher gas flame, turn the knob clockwise to the left (Fig. 7).

1. By turning the ignition knob to the right again (Fig. 4), you will shut off the gas supply and the fire will go out.

Then, the gas cylinder has to be closed.

6.5 WARNING – IF YOU SMELL GAS

Never ignite the unit if you smell gas. If the unit is on when you smell gas, you have to interrupt the gas supply (close the gas

cylinder or the gas valve). Then, check all of the connections for leaks. To do so, moisten all of the gas connections with soapy

water or use a gas leak detection spray. If bubbles arise in the suds or the gas leak detection spray, there is a leak. You can only

use the unit again after all the leaks have been sealed. Please consult your dealer, if necessary.

Fig. 4

Fig. 7

3. The gas outdoor fireplace is operated with the gas regulator

located behind the fireplace door.

4. In order for the gas to be able to flow to the burner, the

tip-protection (Fig. 3) has to be aligned horizontally.



Fig. 5

Fig. 8



Fig. 6

neocube-o | 17

Fig. 3