Datalogic HANDSCANNER 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} Datalogic HANDSCANNER에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Datalogic HANDSCANNER 3 페이지.

페이지 인쇄

TROUBLESHOOTING

HANDSCANNER IS NOT WORKING

PROBLEM

HandScanner is not reacting /

HandScanner is not scanning

a barcode.

Battery symbol of the HandScanner

flashes red.

HANDSCANNER SCANS BADLY

PROBLEM

The crosshairs

(

)

scan dot

light up, but

(

)

the barcodes are hard to scan.

NO TRANSMISSION OF BARCODE DATA

PROBLEM

Barcode data is not transferred.

PROBLEM COULD NOT BE SOLVED?

Hard Reset:



1. Insert the HandScanner in the Hand Trigger.

2. Hold the trigger pressed for about 15 seconds

3. Release the trigger. Press the trigger again for

about 2 seconds to reactivate the HandScanner.

STANDARD SETTINGS:

DIRECTIVES AND CERTIFICATION:

Barcode Suffix: Enter (CR)

2014/53/EU Radio Equipment Directive (RED)

2011/65/EU Restriction of Hazardous Substances (RoHS)

820118500 Rev. A

SOLUTION

Battery is not charged.

Charge the HandScanner in the Datalogic Charging Station for



at least 20 min.

Hand Trigger is defective.

Change the Hand Trigger.



Battery charge is low.

Charge the HandScanner in the Datalogic Charging Station for



at least 20 min.

SOLUTION

HandScanner glass is dirty.

Clean the HandScanner glass with a cotton swap.



Scanning distance is not optimally used.

Position the HandScanner closer or further away from the



barcode label and scan.

For standard range: 3.9 - 31.5 in (10-80 cm)

For mid range: 11.8 - 59 in (30-150 cm).

The barcode label cannot be read.

Create new barcode label.



SOLUTION

HandScanner is not connected to the end device.

1. Scan the Pairing Barcode on the end device /

Datalogic Gateway / in Insight Mobile App.

2. Wait until the HandScanner is connected to the end device and

lights up blue twice briefly after a successful connection.

NEED HELP?

datalogic.com/support



Datalogic S.r.l.

Via San Vitalino 13

40012 Lippo

Calderara di Reno BO, Italy