CB2 HALOGEN 조립 지침 - 페이지 2
{카테고리_이름} CB2 HALOGEN에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. CB2 HALOGEN 4 페이지. Credenza
페이지 인쇄halogen
large
screws
With the assistance of another adult, fit dowels of
assembled unit into corresponding holes of
bottom panel as shown. Attach bottom panel
5
with 6 large screws using a screwdriver.
shelf
pins
Insert 8 shelf pins into holes at desired shelf height.
Place adjustable shelves onto assembled unit.
7
Make sure shelf is securely supported by shelf pins.
Made in Thailand - r04
CREDENZA
adjustable panels
Customer Service 800.606.6252 | Latest instructions available at www.cb2.com
Attach each leg and center leg with 4 small
6
screws using a screwdriver as shown.
Insert bottom edge of right door panel into rear
groove on bottom panel as shown. Tilt door
panel up into a vertical position and hold both
levers at top of door down. Align top of door with
rear groove in underside of shelf and release levers.
8
Repeat for left door panel into front groove.
leg
center
leg
right
door panel
left
door panel
Page 3 of 4