CB2 HALOGEN 조립 지침 - 페이지 3
{카테고리_이름} CB2 HALOGEN에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. CB2 HALOGEN 4 페이지. Credenza
페이지 인쇄halogen
cam screws
Insert 6 cam screws into top panel as shown.
Secure, but do not over tighten, using a phillips
1
head screwdriver.
NOTE: Make sure
unfinished edge of center
panel is facing the back
during assembly
center panel
left
side
panel
Fit dowels of center, left and right side panels into
corresponding holes of top panel as shown. Make
sure grooves on the side panels are on the same
side as the top panel. With a screwdriver, turn each
3
cam clockwise until it securely engages each cam
screw.
Made in Thailand - r04
CREDENZA
NOTE: Do not
over tighten cam screws
right
side
panel
top panel
NOTE: Make sure grooves
on the side panels are on
the same side as the top panel
Customer Service 800.606.6252 | Latest instructions available at www.cb2.com
NOTE: Make sure arrows
on each cam points towards
nearest edge with holes
A. Insert 2 cams and 4 wood dowels into left and
right side panels and center panel as shown.
Make sure arrows on each cam points toward
2
nearest edge with holes as shown.
With the assistance of another adult, slide back
panel down into grooves of top and side panels as
4
shown.
left and right
side panels
center panel
back panel
NOTE: Make sure
sticker on back panel
is facing outwards
during assembly
Page 2 of 4