CBC H2 사용 설명서 - 페이지 3

{카테고리_이름} CBC H2에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CBC H2 4 페이지. Security camera housing

1. UNPACKING

Unpack carefully. This equipment should be handled with care.

Check for the following items:

• Verify the unit model number.

• Verify that parts listed below have been included.

If an item appears to have been damaged in shipment, replace it properly in its carton and notify the shipper. If

any items are missing, notify your dealer or manufacture's Sales Representative or Customer Service. The shipping

carton is the safest container in which the unit may be transported. Save it for possible future use.

Hardware Kit

2 x ¼‐20 x 3/8" Hex Cross Recessed Head Screws

1 x ¼" Flat Washer

1 x ¼" Lock Washer

2. INSTALLATION

Tools required:

#2 Cross Recessed Screwdriver (Phillips)

1/8" Width Flat Blade Screwdriver

3/4" Open End Wrench

General Purpose Wire Stripper with Cutter

Optional: Adjustable Wrench

Materials required:

Outdoor Rated Cables for Power and Video

Cables must be round in shape with an outer jacket diameter of 0.170" minimum to 0.310" maximum.

1. Choose desired location for camera housing installation. Verify mounting structure and surface is capable of

supporting the camera and no obstacle or interference is present from existing installed devices or wiring.

2. Open housing by loosen the 2 Phillips head screws located on the

rear cap. Do not remove the lower two screws on the rear cap.

3. Holding the housing base securely, grasp front cap and cover,

pull forward sliding the cover off the base.

Grasp Here

4. Remove camera mounting bracket by loosen two retaining screws. Slide and lift bracket.

5. Attach camera and lens to bracket using ¼‐20 screw. The position of the camera can be adjusted by flipping

the bracket. The lens must not extend more than ¾" (0.750") beyond the front edge of the bracket.

6. Choose cable entry path for power and video. Using ¾" wrench, install cable gland fittings either in the rear

cap or mounting foot depending on the entry point chosen. Install plugs in the holes not used for cable entry.

Slide

Page 3

Loosen

These

Screws

Do Not

Remove