Datalogic POWERSCAN PBT7100 guide 빠른 참조 매뉴얼 - 페이지 16
{카테고리_이름} Datalogic POWERSCAN PBT7100 guide에 대한 빠른 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Datalogic POWERSCAN PBT7100 guide 20 페이지. Cordless imaging reader
Datalogic POWERSCAN PBT7100 guide에 대해서도 마찬가지입니다: 빠른 참조 매뉴얼 (16 페이지)
페이지 인쇄
How to Scan
When the trigger is pressed, a red laser aiming beam is activated, enabling the user to align its hori-
zontal and vertical position with the desired barcode. The aiming beam will remain on until a con-
1
figurable time-out
period elapses, then the red scan LEDs are activated to read the barcode.
If the barcode is not decoded before another configurable period has expired, the laser aiming beam
will begin blinking to allow the user to continue pointing the reader at the desired barcode.
NOTE
Barcodes :
To scan, center the illumination beam over the barcode as shown in
reader must "see" across the width of all of the bars. Move the reader further away from the barcode
to increase the scanning coverage area, and closer in to read very small barcodes.
Figure 1-4. Scanning Barcodes
Troubleshooting
Troubleshoot your scanning system by performing the following checks:
Troubleshooting the BT System
For the BT system, ensure...
1. Reference the Product Reference Guide (PRG) for more information about the aiming
beam time-out period. (Default for the time-out is 100mS.)
14
If the surface being scanned is highly reflective (e.g., lami-
nated), it may be necessary to tilt the item or the reader slightly
(15° to 18°) to prevent unwanted reflection.
Decrease...
PowerScan® PBT7100 Cordless Imaging Reader
(Green spot provides
good read feedback)
...or Increase distance
from bar code to adjust
aiming beam width to
cross all bars.
Figure 1-4
. The