ADE HW 945 Series 운영 매뉴얼 - 페이지 6

{카테고리_이름} ADE HW 945 Series에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ADE HW 945 Series 12 페이지. Electronic table scales

Power the scale by pressing the tilting switch underneath the base (left hand side).

For approx. 3 sec the display shows "SYS - UP" followed by a test run 0000, 1111, 2222

followed by Volt 6.0 (depending on loading status).

Finally the scale is changing into weighing mode and shows 0 on display.

Set zero

By using the Zero key eventual irregularities occurred after start up the scale can be

compensated by setting the display back to zero for all subsequent weighing procedures.

Tare Function

This function enables the user to weigh objects together with others (e.g. container, foil or

paper cloth) without the additional weight influencing the weighing result.

Start up the scale.

If necessary use the manual zero function (see above under Set zero) pressing the

Zero key if necessary. The Zero indication appears on display.

Place the object (e.g. container, foil or paper cloth) on the tray.

Press Tare key to come back to zero. Display now shows `0.00´ and the Tare symbol

will appear.

Put the object to be weighed on the platform.

The weight of object can be read from the display.

If the objects to be tared will always bet he same you may continue weighing another object

and the scale will only show the weight of the individually weighed object. In case the scale is

shut off automatically (e.g. n battery operating mode) the stored value is cleared. If the value

to be tared is changing during operation of the scale, complete unloading of the scale is

necessary. Press Tare key again to return to normal status.

Unit function

By using the Unit key you may select the weighing mode (kg, g, lb).

Before weighing always make sure you are in the selected weighing mode.

Use of the scale

HW945-210409-Rev006-UM-en