Datamax Apex 3 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} Datamax Apex 3에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Datamax Apex 3 4 페이지. Portable thermal receipt printer
Datamax Apex 3에 대해서도 마찬가지입니다: 사양 (4 페이지), 사양 (4 페이지)

페이지 인쇄

Installing the Battery

1. Unlock the battery door by sliding the battery door locking tab down.

2. Open the battery door to an angle of approximately 90 degrees.

(Do not force the door open)

3. Insert battery as shown (non-contact end ﬁ rst) letting the contact end drop

into place.

4. Close the battery door and then lock the battery door by sliding the

battery door locking tab up.

Charging the Battery

1. Plug the battery charger adaptor output cable into the battery charger

connector.

2. Plug the battery charger adaptor into the appropriate AC line voltage

socket.

3. The LED will illuminate indicating that the battery is being charged.

4. The battery will be fast charged and, after 180 minutes, the LED will turn off.

Note: Ensure battery is properly seated before

closing door and that the battery side that

Battery

has the 2 contact terminals is facing down

Door Tab

to make contact with the spring probes

inside the battery compartment