Datamax H-Class 매뉴얼 - 페이지 13

{카테고리_이름} Datamax H-Class에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Datamax H-Class 14 페이지. Cutter option
Datamax H-Class에 대해서도 마찬가지입니다: 매뉴얼 (8 페이지), 빠른 시작 매뉴얼 (12 페이지), 매뉴얼 (10 페이지), 매뉴얼 (12 페이지)

페이지 인쇄

Step 4: Configuring the Software Settings

Configure the printer's m

A) Using the Control Panel, enter the ADVANCED MENU (see the Operator's Manual for

menu navigation details):

If using the GPIO A (J1) port, configure the settings to meet the requirements of

•

your system using the PRINTER OPTIONS  GPIO PORT  APPLICATOR

menu selection;

If using the GPIO B (J2) port, refer to your MCL documentation;

•

If using the COM C (J4) port for serial communications, configure the it to meet the

•

requirements of your host system's serial port settings using the

COMMUNICATIONS  SERIAL PORT C menu selection; or,

If using the COM C (J4) port for a dedicated device, enable that device using the

PRINTER OPTIONS menu selection; and,

If using the COM D (J3) port for serial communications, configure the port to meet

•

the requirements of your host system's serial port settings using the

COMMUNICATIONS  SERIAL PORT D menu selection.

B) After entering the desired settings exit the menu system and save your changes. The

printer is now ready to operate using the GPIO option.

Verifying Setup and Operation

Verification of the settings and active monitoring is provided:



Indicators – View incoming (IN) and outgoing (OUT)

signal activity via the card bracket. Sampled every

millisecond, these LED indicators change color as incoming

or outgoing GPIO signals change state.

for the option's operation.

enu settings

Signal In

Signal Out