Datamax M-Class Mark II 빠른 시작 매뉴얼 - 페이지 5
{카테고리_이름} Datamax M-Class Mark II에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Datamax M-Class Mark II 6 페이지. Rfid option
Datamax M-Class Mark II에 대해서도 마찬가지입니다: 매뉴얼 (6 페이지), 매뉴얼 (8 페이지), 빠른 시작 매뉴얼 (4 페이지), 매뉴얼 (10 페이지), 빠른 시작 매뉴얼 (8 페이지), 빠른 시작 매뉴얼 (8 페이지)
페이지 인쇄
Media Loading
Load media into the printer as you normally would for tear-off operation (see the Operator's Manual
for details), however, extend an additional 12 inches (30 cm) of media out the front of the printer.
Route the Media over the Arc Plate and around the Internal Rewinder, as shown below.
Media
Arc Plate
Note: The Media Retainer can be used in place of the Media Clip for a more consistent rewound roll. The Media
Clip and Media Retainer cannot be used together.
Put the leading edge of the Media into a Slot on the Internal Rewinder and insert the Media Clip. Be
sure the leading edge of the Media is cut square and that is inserted evenly into the slot.
Manually rotate the Internal Rewinder to remove slack from the Media.
Plug in and turn 'On" the printer. After initialization, press the FEED Button to align the next label to
the top of form position. The printer is now ready to rewind printed labels.
Unloading the Internal Rewinder
When the Internal Rewinder becomes full, remove the Media Clip. Grasp the used media and carefully
pull it from the Internal Rewinder.
Note: Never allow the outer diameter of backing material to exceed 4 inches (102 mm) on the Internal Rewinder.
Internal Rewinder
3
Media
Slots
Media Clip
Retainer
Thumbscrew