Datamax M-Class Mark II Skrócona instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Czytnik kodów kreskowych Datamax M-Class Mark II. Datamax M-Class Mark II 6 stron. Rfid option
Również dla Datamax M-Class Mark II: Podręcznik (6 strony), Podręcznik (8 strony), Skrócona instrukcja obsługi (4 strony), Podręcznik (10 strony), Skrócona instrukcja obsługi (8 strony), Skrócona instrukcja obsługi (8 strony)

Media Loading

 Load media into the printer as you normally would for tear-off operation (see the Operator's Manual

for details), however, extend an additional 12 inches (30 cm) of media out the front of the printer.

 Route the Media over the Arc Plate and around the Internal Rewinder, as shown below.

Media

Arc Plate

 Note: The Media Retainer can be used in place of the Media Clip for a more consistent rewound roll. The Media

Clip and Media Retainer cannot be used together.



Put the leading edge of the Media into a Slot on the Internal Rewinder and insert the Media Clip. Be

sure the leading edge of the Media is cut square and that is inserted evenly into the slot.



Manually rotate the Internal Rewinder to remove slack from the Media.



Plug in and turn 'On" the printer. After initialization, press the FEED Button to align the next label to

the top of form position. The printer is now ready to rewind printed labels.

Unloading the Internal Rewinder

When the Internal Rewinder becomes full, remove the Media Clip. Grasp the used media and carefully

pull it from the Internal Rewinder.

 Note: Never allow the outer diameter of backing material to exceed 4 inches (102 mm) on the Internal Rewinder.

Internal Rewinder

Media

Slots

Media Clip

Retainer

Thumbscrew