Datapath VisionSC-HD4+ 사용자 설명서 - 페이지 12

{카테고리_이름} Datapath VisionSC-HD4+에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Datapath VisionSC-HD4+ 16 페이지. Audio and video capture card
Datapath VisionSC-HD4+에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄
Datapath VisionSC-HD4+ 사용자 설명서

Installing Multiple Cards

Multiple cards can be installed in a system providing a large number capture channels. Combinations of
Vision capture cards in the same machine are supported by the Vision driver.
In order to control the order in which the driver uses the cards, it is recommended when installing multiple
cards that the
J5
links on the VisionSC-HD4+ are configured. The example below shows the jumper link
settings for up to 32 cards in a single system. When two cards share the same link settings, their order is
determined by the PCIe bus.
DirectShow
If you change the link ordering after installation you must run dplinks.exe. This program will update the
existing input names used by the windows DirectShow interface.
To run the dplinks program open the Run dialogue by clicking on Start/Run and type dplinks and then
press Enter.
The program will run, however no notifications are displayed.
Fig.5
10