Datapath VisionSC-HD4+ 사용자 설명서 - 페이지 13

{카테고리_이름} Datapath VisionSC-HD4+에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Datapath VisionSC-HD4+ 16 페이지. Audio and video capture card
Datapath VisionSC-HD4+에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄

Firmware Upgrades

The VisionSC-HD4+ cards allow firmware upgrade to be completed on site rather than returning the card

to Datapath. Whenever a firmware upgrade is performed, the SW2 on the DIP switch must be set ON. The

DIP Switch can be located on the back of the VisionSC-HD4+ (See Fig. 6 ) To perform the upgrade, follow

the step-by-step instructions provided by the upgrade application. The VisionSC-HD4+ is shipped with the

SW2 switch set at on, therefore no action should be necessary.

In the unlikely event that something goes wrong during the upgrade process (e.g. System power outage) it

is possible to revert to the factory settings by powering down the system, temporarily setting SW2 to the

OFF position then powering up the system. Once the system has rebooted, set the SW2 back to the ON

position (while the system is still powered up) and restart the firmware upgrade process.

It should be noted that the latest driver installation program includes an automatic firmware update, if

required. Therefore, prior to installing the application and driver, ensure that SW2 is set to on.

Fig.6