Datapath Aetria WallControl VSN Series 빠른 시작 매뉴얼 - 페이지 5
{카테고리_이름} Datapath Aetria WallControl VSN Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Datapath Aetria WallControl VSN Series 17 페이지.
페이지 인쇄
Aetria WallControl Quick Start Guide
STEP 5 - CONNECTING A CONTROL SCREEN
Your VSN wall controller is configured to use a control screen connected to the systems internal graphics device
prior to leaving the factory. Connect the control screen to the motherboard graphics output connector on the
rear of the VSN wall controller. A control screen is initially required to set up the system including the operating
system (Windows 10).
VGA or DVI
Control Screen
STEP 6 - POWERING UP THE SYSTEM
VSN wall controllers are supplied with either a Redundant Power Supply Unit (RPSU) or an ATX power supply.
An RPSU power supply requires two power cables and an ATX supply requires one power cable.
All power cables are supplied with your VSN wall controller.
1
1
2
2
RPSU Power Switch
ATX Power Switch
5