Datapath Aetria WallControl VSN Series 빠른 시작 매뉴얼 - 페이지 6

{카테고리_이름} Datapath Aetria WallControl VSN Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Datapath Aetria WallControl VSN Series 17 페이지.

Aetria WallControl Quick Start Guide

Connect power cable(s) to the VSN wall controller then plug into a mains supply.

Switch on the power supply units.

Switch on the system using the power button on the front panel.

Note: If you have a VSN Expansion Chassis connected to the main unit (Step 2), the power supply units on the

expansion chassis should be switched on prior to the main VSN wall controller. There is no requirement to switch

on the expansion chassis on the front panel (3).

STEP 7 - WINDOWS 10 SETUP

Once the system has been built and configured in our factory, the operating system is resealed. Therefore, when

switching the system on for the first time, the operating system setup commences. You will be prompted to

enter information to set up the Windows 10 operating system.

There is no requirement for users to activate Windows 10, activation is done automatically.

An internet connection is required for the automatic activation.

You are strongly recommended to create a 'Restore USB Flash Drive' . (See Step 9)