Datapath Express9 사용자 설명서 - 페이지 6

{카테고리_이름} Datapath Express9에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Datapath Express9 15 페이지.

Installing the Express9 Backplane

The Express9 backplane is fixed into the chassis by screwing down on the mounts located in

the host chassis. Ensure the rear of the Express9 backplane is facing the rear of the chassis.

The chassis will have a number of locating mounts not used by the Express9, it is important

that stand off mounts are used to ensure the reverse side of the backplane does not come

into contact with any unused mounts.

Once the Express9 is secured inside the chassis connect the power supply to one of the four

connectors (J1, J2, J3, and J4) on the Express9 backplane and connect the 12v supply (J5 or

J6).

Connect the fan headers

There is no requirement to connect the power reset cable unless using an SBC.

09/03/2011