Dux Proflo 315S1 소유자 매뉴얼 - 페이지 7

{카테고리_이름} Dux Proflo 315S1에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dux Proflo 315S1 20 페이지. Owner’s information warranty installation details electric storage water heaters
Dux Proflo 315S1에 대해서도 마찬가지입니다: 소유자 매뉴얼 (20 페이지)

페이지 인쇄
Dux Proflo 315S1 소유자 매뉴얼
between the non return valve and the
water heater. See the diagram below for
details.
Hot Water Connection
The hot water pipe should be connected
to either of the RP¾/20 sockets marked
OUTLET at the top of the unit. For the
most economical operation of the water
heater, it is recommended that all hot
water lines are insulated. Please check
local regulations regarding the use of
hot water supply pipework that are not
made of copper.

Insulation of Pipes

All hot water pipes must be insulated
with UV stabilized insulation suitable
for solar working temperatures, e.g.
Armaflex Insulation.
Inlet Connections
Note: a combined isolating valve/non-return valve/line strainer may be used.
Expansion valve only required where local regulations demand.
H0421
0421
Rev. J
Owner's Manual – Proflo Electric Storage Water Heaters
Plumbing Connections
Isolating Valve
(Spindle Vertical)
Cold Water
Inlet
Temperature Protection
Water heaters can produce very hot
water. To reduce the risk of scald injury,
it is mandatory under the requirements
of Australian Standard AS/NZS3500.4.2
that a suitably approved temperature
control device be fitted to the hot water
supply to outlets used primarily for
personal hygiene. This valve should be
checked at regular intervals to ensure its
operation and settings remain correct.
Drain
Line
Non-return
Strainer
Valve
Expansion
Valve
Union
Connection
5