Dux Proflo 315S1 소유자 매뉴얼 - 페이지 8

{카테고리_이름} Dux Proflo 315S1에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dux Proflo 315S1 20 페이지. Owner’s information warranty installation details electric storage water heaters
Dux Proflo 315S1에 대해서도 마찬가지입니다: 소유자 매뉴얼 (20 페이지)

페이지 인쇄

This water heater is designed for

single phase 240V A.C supply only.

The electrical connection must

comply with Local Supply Authority

Regulations and AS/NZS3000.

For models pre-wired with a flexible

lead, if the supply cord is damaged, it

must be replaced by the manufacturer,

its service agent, or similarly qualified

person in order to avoid hazard.

For models not pre-wired with a flexible

lead, connections are made at the

terminal block inside the water heater,

and a means for disconnection must

be incorporated in accordance with the

wiring rules.

Entry to the connection area is through

the hole beneath the element cover,

designed to accept a 20mm conduit.

The element cover may be removed by

undoing the two screws on the cover

and sliding the cover downwards to

disengage the top edge. Ensure that the

conduit entry is well sealed to achieve

correct weatherproofing.

Note: This water heater is fitted with

a thermostat and over-temperature

energy cut-out. Under no circumstances

should the water heater be operated

without both these devices being in the

circuit. Replacement must be carried

out only by a qualified electrician or the

manufacturer.

Owner's Manual – Proflo Electric Storage Water Heaters

Electrical Connection

Danger: The operation of the thermal

cut-out indicates a possibly dangerous

situation. Do NOT reset the thermal

cutout until the water heater has been

serviced by a qualified person.

Caution: Water heater must be filled

with water before turning on the

electricity supply.

Electrician: Press the reset button on

thermostat to ensure over-temperature

cut-out is set.

When supply wiring has been connected,

supply wires must be kept lower than the

terminal block.

H0421

0421

Rev. J