Dataq Instruments DI-194RS 사용자 설명서 - 페이지 15

{카테고리_이름} Dataq Instruments DI-194RS에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dataq Instruments DI-194RS 18 페이지. 4-channel data acquisition module

4. Connecting Your Input Sig-

nals to the DI-194RS

DO NOT CONNECT INPUT SIGNALS TO YOUR DEVICE UNTIL YOU HAVE READ "CAUTION" on

page v. All input signal connections are made to the 8-port screw terminal. Each terminal is labeled directly on the

circuit board. Refer to the following for screw terminal port identification:

CH 1: Channel 1 analog signal input.

CH 2: Channel 2 analog signal input.

CH 3: Channel 3 analog signal input.

CH 4: Channel 4 analog signal input.

Gnd: Ground.

Dig 0: Digital port 0.

Dig 1: Digital port 1.

Dig 2: Digital port 2.

To connect signals to the DI-194RS, insert the stripped end of a signal lead into the desired terminal directly under the

screw. Tighten the pressure flap by rotating the screw clockwise with a small screwdriver. Make sure that the pres-

sure flap tightens only against the signal wire and not the wire insulation. Do not over-tighten. Tug gently on the sig-

nal lead to ensure that it is firmly secured.

Connecting Input Signals

DI-194RS User's Manual