AGRI-COVER Command-10 사용 설명서 - 페이지 8
{카테고리_이름} AGRI-COVER Command-10에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AGRI-COVER Command-10 17 페이지.
페이지 인쇄Programming a Remote Control to
a Receiver
Your Remote and Receiver will come pre-programmed to each other.
If they are not, follow the procedure below.
STEP 1
Clear Receiver
Power on receiver. Press and hold the Programming button until the
indicator light turns steady green. Power off Receiver.
Power
On/Off
Switch
STEP 2
Create Primary Remote
Clear Remote - open cover to unlock remote. Push and hold Select button
then push and hold Programming button while Select button is still being
held. Hold both buttons until indicator light flashes red. Release both buttons.
Press CLOSE button. Indicator light will fast flash red then turn steady
green. Close Lid to power down and lock remote. Remote is now cleared.
Open cover to unlock remote. Push and hold Select button then
push and hold Programming button
while Select button is still being held.
Hold both buttons until indicator light
flashes red. Release both buttons.
Press OPEN button. Indicator
light will slow flash green.
Primary Remote has been
created. Close lid to power
down and lock remote.
8
Figure 6 – Receiver
Open Button
Select
Button
Indicator
Light
Open
Close
Switch
Programming
Button
Indicator
Light
Figure 7 – Remote
Programming
Button