AGRI-COVER Command-10 사용 설명서 - 페이지 9

{카테고리_이름} AGRI-COVER Command-10에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AGRI-COVER Command-10 17 페이지.

Program Primary Remote to Receiver
Power on both receiver and remote. On remote tap Programming button
once, indicator light will flash fast green. On receiver, press and hold
Programming button until both remote and receiver slow flash green at
the same rate. Remote and Receiver are now programmed. By default the
Remote will be programmed to the tarp setting.
Optional Instructions to Enable
and Program Additional Modes on
Remote Control
(adding additional Receiver)
Clear Additional Receiver
a.
Power on Receiver.
Press and hold the Programming button until the indicator light turns
b.
steady green.
c.
Power off Receiver.
Program Primary Remote to Additional Receiver
NOTE: Be sure that only the Remote that you are working with is
powered up.
a.
Power on both Additional Receiver and Primary Remote
b.
On Remote tap Program button once, indicator light will flash fast green.
c.
Use the Select button to select one of the 10 programmable locations.
d.
On Additional Receiver, press and hold Programming button until both
Remote and Additional Receiver slow flash green at the same rate.
e.
Remote and Additional Receiver are now programmed.
Caution: If TARP function is selected the previous receiver will be
overwritten.
STEP 3
STEP 1
STEP 2
9