DV8 OFFROAD CCT2-01 설치 매뉴얼 - 페이지 3

{카테고리_이름} DV8 OFFROAD CCT2-01에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DV8 OFFROAD CCT2-01 4 페이지. Tundra center console and bridge

INSTALLATION

MANUAL

STEP 3

Use an 11/32" drill bit to drill out the marked

mounting positions.

Note: Drill accurately and carefully to avoid scuff-

ing the trim unnecessarily. Do not drill any further

than the center console trim. It may be helpful to

pull the center console trim back slightly to en-

sure you are drilling only through center console

trim.

STEP 3

(Optional) You may choose to install the

provided M6 nutserts with a nutsert tool for

an easier installation.

We do highly recommend using a nutsert

on the driver side front upper mounting

hole due to how to difficult it is to reach

back with a nut.

STEP 4

If you installed nutserts, drop the center

console and bridge into place and secure

using provided M6 hardware and a 4mm

allen bit.

If you did not use nutserts, press the M6

hardware through the mounting holes to

hold it in place.

Pull back on the center console trim to

install the serrated nuts. Use a 4mm allen

bit while applying pressure with your hand

on the serrated nut until "catches" and is

secured.

NEED HELP?

855-680-9595