DV8 OFFROAD CCT2-01 Посібник з монтажу - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник з монтажу для Автомобільні аксесуари DV8 OFFROAD CCT2-01. DV8 OFFROAD CCT2-01 4 сторінки. Tundra center console and bridge
Друкувати сторінку
INSTALLATION
MANUAL
STEP 3
Use an 11/32" drill bit to drill out the marked
mounting positions.
Note: Drill accurately and carefully to avoid scuff-
ing the trim unnecessarily. Do not drill any further
than the center console trim. It may be helpful to
pull the center console trim back slightly to en-
sure you are drilling only through center console
trim.
STEP 3
(Optional) You may choose to install the
provided M6 nutserts with a nutsert tool for
an easier installation.
We do highly recommend using a nutsert
on the driver side front upper mounting
hole due to how to difficult it is to reach
back with a nut.
STEP 4
If you installed nutserts, drop the center
console and bridge into place and secure
using provided M6 hardware and a 4mm
allen bit.
If you did not use nutserts, press the M6
hardware through the mounting holes to
hold it in place.
Pull back on the center console trim to
install the serrated nuts. Use a 4mm allen
bit while applying pressure with your hand
on the serrated nut until "catches" and is
secured.
NEED HELP?
855-680-9595