DV8 OFFROAD RBJL-12 설치 매뉴얼 - 페이지 6

{카테고리_이름} DV8 OFFROAD RBJL-12에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DV8 OFFROAD RBJL-12 13 페이지. Jl mid width rear bumper

INSTALLATION

MANUAL

STEP 8 |

Push the sensor bezels

into place. The outside bezels should be

facing downwards, and the two inside

bezels should be facing down and

inwards away from the d-ring.

A rubber mallet can be used to lightly tap

them into place. The bezels should be flat

against the bumper.

STEP 9 |

With the bezels in place, run

the sensor wiring harness though cavity

in the bumper aligning the sensors with

the bezels. Push Sensors into bezels

ensure they have "clicked" into place.

Secure sensor harness using provided zip

tie tabs.

Note: If your jeep has factory metal

bumpers, one of the wires in the harness

will need to be lengthened. If equipped

with factory plastic bumpers, Skip to

step 13.

NEED HELP?

855-680-9595