Convoy Technologies RVM-0744 설치 매뉴얼 - 페이지 4

{카테고리_이름} Convoy Technologies RVM-0744에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Convoy Technologies RVM-0744 6 페이지. Rearview mirror monitor

Owner's / Installation Manual

Performance Series

Mounting the RearView Mirror Monitor

1) Loosen the set screw holding the installed rearview mirror in place, and carefully slide it off its base. The Convoy RVM-0744

will use the installed base on the windshield.

2) Mount the supplied windshield bracket to the back of the RVM-0744 with the supplied screws. Slide the bracket onto the base

on the windshield, tighten the locking screw. Route the cable up under the headliner to the A pillar and down.

3) The device may be powered by a 12 or 24 volt automotive battery or vehicle electrical system.

4) Make sure all cables are connected properly, observe polarity. Improper cable connections may damage the monitor. Remove

the power cable connections when you do not intend to use the unit.

Function Keys:

Power = Power On/Off

= a. Quad (AV1-4) and triple (AV1-3) images display switch

b. Adjust up numbers of options in menu pages

MENU = a. Enter Menu

b. Turn Menu Page

= a. Dual images display switch: (AV1-2) TO (AV3-4)

b. Adjust down numbers of options in menu pages

= a. Single channel switch (AV1, AV2, AV3, AV4)

b. As option choosing button in menu page

Please read this manual thoroughly before operating the unit, and keep it for further reference.

Convoy Technologies 6409 Highview Drive | Fort Wayne, IN 46808 | Ph (888) 565-2583

RVM-0744

1. CH1-Brown, CH1 Trigger—Brown (12VDC)

2. CH2-White, CH2 Trigger—White (12VDC)

3. CH3-Yellow, CH3 Trigger—Yellow (12VDC)

4. CH4-Blue, CH4 Trigger—Blue (12VDC)

5. Red to Power (9-48VDC +)

6. Black to Ground

7. 13 pin din to Monitor