Convoy Technologies RVM-0744 설치 매뉴얼 - 페이지 6

{카테고리_이름} Convoy Technologies RVM-0744에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Convoy Technologies RVM-0744 6 페이지. Rearview mirror monitor

페이지 인쇄

Owner's / Installation Manual

Performance Series

Installation Notes

•

12v to the trigger wire will turn the monitor and camera on, and focus on that camera. When trigger voltage is removed,

monitor will turn off, or go back to its previous state.

•

AV1 does not have a trigger wire. There is a distance grid superimposed on AV2, for the backup camera view.

•

Trigger delay times on Menu Page 5 are useful if you install sideview cameras triggered by turn signals. If you connect your

12v trigger wire to a pulsing wire, increasing the delay will keep the camera turned on instead of turning on and off when the

turn indicators flash, allowing the driver to view the camera on the inside of the turn until the turn is complete.

Troubleshooting

Symptom

possible Causes/Solutions

No picture. No sound

Improper connection of automobile adapter. Use of un-authorized power supply. Power switch is on OFF position

No picture

Check whether locking cable is properly connected.

No sound

Check whether locking cable is properly connected, or the volume is set too low

Dark picture

Check whether brightness and contrast are adjusted correctly, and note if the temperature is at or below –10°C.

No color

Adjust the color settings.

No reversing function

Check the wires (black/ red/ blue) that may be loose

(i.e. Picture)

Specifications

7" TFT-LCD

Audio Output:

Loudspeaker:

Power Supply:

Power Consumption:

Outer Dim (WxHxD):

Resolution:

Contrast:

Brighttness:

Viewing Angle:

Operating Temperature:

Storage Temperature:

Please read this manual thoroughly before operating the unit, and keep it for further reference.

Convoy Technologies 6409 Highview Drive | Fort Wayne, IN 46808 | Ph (888) 565-2583

RVM-0744

Subject to the provisions described below, this CT product is protected for 1

Color Monitor

year against defects in material and workmanship. Should a product fail to

0.5 W

perform as described above within the warranted period, it will be repaired or

replaced with the same or functionally equivalent product by CT. This warrant

1ea 15x40mm

does not apply if , in the judgement of CT, the product fails due to damage

10-24V

from shipment, handling, storage, accident, abuse or misuse, or if it has been

6.6W Max, 260mA

used or maintained in a manner not conforming to product manual instruc-

tions, has been modified in any way. Repair by anyone other than CT or an ap-

9-⁷⁄₈"x 4-¼"x 1-¼"

proved agent will void this warranty. The maximum liability of CT under this

800W x 480H

warranty is limited to the purchase price of the product covered by the warran-

ty. All defective products should be returned to CT with shipping charges pre-

300:1

paid. CT will not accept collect shipments.

500cd/m²

40°V x 60°H

-10°- +60°C, RH90%

-20° - +70°C, RH90%

Warranty and Support Information